Headlamp Alignment Control Module: Service and Repair

Headlamp Leveling Module

Removal
1 Disconnect the battery ground cable. For additional information, refer to Specifications [1][2]Battery
2 Remove the blower motor. For additional information, refer to Blower Motor Service and Repair




3
NOTE:
LH illustration shown, RH is similar.
Remove the RH cowl side trim panel.




4 Remove the subwoofer cover.
- Reposition the carpet for access.
- Remove the 4 bolts.




5 Remove the headlamp leveling module.
- Remove the 2 bolts.
- Disconnect the electrical connector.

Installation
1 To install, reverse the removal procedure.
2 Install the headlamp leveling module.
- Tighten the bolts to 3 Nm (2 lb.ft).
3 Install the subwoofer cover.
- Tighten the bolts to 10 Nm (7 lb.ft).