Headlamp Leveling Front Sensor

Headlamp Leveling Front Sensor

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the LH front wheel and tire. For additional information, refer to Wheel and Tire Service and Repair




3 Remove the headlamp levelling sensor.
- Disconnect the height sensor link.
- Disconnect the electrical connector.
- Remove the 2 bolts.
4
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the height sensor link.




5
NOTE:
Note the fitted position.
Remove the bracket.
- Remove the 2 Allen bolts.

Installation
1
NOTE:
Align to the position noted on removal.
Install the bracket.
- Tighten the Allen bolts to 5 Nm (4 lb.ft).
2 Install the height sensor link.
3 Install the headlamp levelling sensor.
- Tighten the bolts to 25 Nm (18 lb.ft).
- Connect and secure the electrical connector.
- Connect the height sensor link.
4 Install the wheel and tire. For additional information, refer to Wheel and Tire Service and Repair