Headlamp Leveling Rear Sensor

Headlamp Leveling Rear Sensor

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.




2 Remove the headlamp levelling sensor.
- Disconnect the height sensor link.
- Disconnect the electrical connector.
- Remove the 2 bolts.




3
NOTE:
Do not disassemble further if the component is removed for access only.
NOTE:
Note the fitted position.
Remove the bracket.
- Remove the 2 Allen bolts.

Installation
1
NOTE:
Align to the position noted on removal.
Install the bracket.
- Tighten the Allen bolts to 5 Nm (4 lb.ft).
2 Install the headlamp levelling sensor.
- Tighten the bolts to 25 Nm (18 lb.ft).
- Connect and secure the electrical connector.
- Install the height sensor link.