Central Junction Box (CJB)

Central Junction Box (CJB)

Removal
1 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications




2
CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
Remove the passenger side footwell trim panel.
- Remove the 3 clips.




3 Remove the cowl side trim panel.
- Remove the Torx screw.
- Remove the hood release lever.
- Release the forward edge of the scuff plate trim panel.
- Carefully release the clips.
4 Release the CJB.
- Release the battery positive cables.




5 Remove the CJB.
- Disconnect the 10 electrical connectors.
- Remove the 2 nuts.

Installation
1 Install the CJB.
- Disconnect the electrical connectors.
- Tighten the nuts to 10 Nm (7 lb.ft).
2 Secure the CJB.
- Attach the battery positive cables.
- Tighten the nut to 25 Nm (18 lb.ft).
3 Install the cowl side trim panel.
- Align the pegs and secure the clip.
- Install the scuff plate trim panel.
- Install the hood release lever and secure with the screw.
4 Install the passenger side footwell trim panel.
- Carefully secure the clips.
5 Connect the battery ground cable and install the cover. For additional information, refer to Specifications
6 Using WDS, configure a new CJB.