P0632

P0632-ODOMETER NOT PROGRAMMED IN PCM

WHEN MONITORED
Ignition on.

SET CONDITION
Odometer is not programed into the PCM. One Trip Fault. Three good trips to turn off the MIL.

POSSIBLE CAUSES
- Programming mileage into the PCM
- PCM

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.

Diagnostic Test

1. PROGRAMMING MILEAGE INTO THE PCM

Ignition on, engine not running.
With the scan tool, erase DTCs.
Using a scan tool, program the mileage into the PCM.
Start the engine.
Allow the engine to reach normal operating temperature.
With a scan tool, read DTCs.

Q: Does the DTC reset?

YES: Replace and program the Powertrain Control Module. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test
NO: The mileage has been successfully programmed into the PCM. Test is complete. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test