P0700

P0700-TRANSMISSION CONTROL SYSTEM (MIL REQUEST)

WHEN MONITORED
Ignition on and battery voltage greater than 10 volts.

SET CONDITION
An active DTC is stored in the TCM. One Trip Fault. Three good trips to turn off the MIL.

POSSIBLE CAUSES
- DTC present in the transmission control module

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.

Diagnostic Test

1. DTC PRESENT IN EATX CONTROLLER

This is an informational DTC letting you know that a DTC(s) is stored in the Transmission Control Module.
Erase this DTC from the PCM after all Transmission DTC(s) have been repaired.
Using a scan tool, read the Transmission Controller DTC and refer to the Transmission Category and perform the appropriate symptom.

PCM Diagnostic Information complete.

Continue
Test Complete.