B1851

B1851-FLIPPER GLASS SWITCH STUCK - CLUSTER





For a complete wiring diagram refer to Diagrams/Electrical.

- When Monitored:

Continuously

- Set Condition:

When the Cluster senses a low condition on the Flip-UP (Flipper) Glass Switch Sense circuit for over 10 seconds, this code will set.





Diagnostic Test

1. TEST FOR INTERMITTENT CONDITION

With the scan tool, record and erase DTC's

Operate the Flip-Up Glass Switch several times.

Cycle the ignition from on to off 3 times.

Turn the ignition on.

With the scan tool, read DTC's.

Does the scan tool display B1851-FLIPPER GLASS SWITCH STUCK?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

2. FLIP-UP GLASS SWITCH STUCK





With the scan tool, erase DTC's.

Disconnect the License Lamp connector.

With the scan tool, read DTC's.

Does the scan tool display FLIPPER GLASS SWITCH STUCK?

No

- Replace the Flip-Up Glass Switch (License Lamp).
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

Yes

- Go To 3

3. (Q80) FLIP-UP GLASS SWITCH SENSE CIRCUIT SHORT TO GROUND





Turn the ignition off.

Disconnect the Cluster C3 connector.

Measure the resistance between ground and the (Q80) Flip-Up Glass Switch Sense circuit.

Is the resistance below 1000.0 ohms?

Yes

- Repair the (Q80) Flip-Up Glass Switch Sense circuit for a short to ground.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Replace the Instrument Cluster.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test