C1413

C1413-4 HI/LO SELECT SWITCH CIRCUIT STUCK





For a complete wiring diagram refer to Diagrams/Electrical. Electrical Diagrams


- When Monitored:

With the ignition on and no system undervoltage or overvoltage condition present.

- Set Condition:

Valid voltage for 4HI/4LO switch active present for a calibratable time or when shifter is not in neutral.







Diagnostic Test


1. NEUTRAL INDICATOR CONTROL CIRCUIT DTC IS ACTIVE

Turn the ignition off to the lock position

With the scan tool, read DTCs in the Final Drive Control Module.

Is the status Active for this DTC?

Yes

- Go to 2

No

- Go to 3
-


2. TRANSFER CASE SELECTOR SWITCH





Turn the ignition off to the lock position

Disconnect the Transfer Case Selector Switch.

Ignition on, engine not running.

With the scan tool, read the 4wd Range Switch Voltage in the Final Drive Control Module.

The switch voltage should be approximately 0.0 volts.

Turn the ignition off to the lock position

Connect a jumper wire between the (K504) Drivetrain 5-volt Supply circuit and the (K977) Mode Select circuit in the Transfer Case Selector Switch connector.

Ignition on, engine not running.

With the scan tool, read the 4wd Range Switch Voltage in the Final Drive Control Module.

The switch voltage should be approximately 5-volts.

Does the voltage display as described?

Yes

- Replace the Transfer Case Selector Switch.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1. Transfer Case Verification Test

No

- Replace the Final Drive Control Module.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1. Transfer Case Verification Test


3. INTERMITTENT WIRING AND CONNECTORS

The conditions necessary to set this DTC are not present at this time.

Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.

While monitoring the scan tool data relative to this circuit, wiggle test the wiring and connectors.

Look for the data to change or for the DTC to reset during the wiggle test.

Were any problems found?

Yes

- Repair as necessary.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1. Transfer Case Verification Test

No

- Test complete.