P0513

P0513-INVALID SKIM KEY

For a complete wiring diagram refer to Diagrams/Electrical

- When Monitored:

With the ignition on.

- Set Condition:

The ECM receives and invalid SKIM Key message from the SKREEM.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.


Diagnostic Test

1. CHECK FOR SKREEM COMMUNICATION AND DTCS

Ignition on, engine not running.

With the scan tool, check for proper communication and active DTCs in the SKREEM.

Are any SKREEM communication problems or DTCs present?

Yes

- Refer to the symptom list for problems related to SKREEM Communication and DTCs before continuing.

No

- Go To 2


2. CHECK FOR ACTIVE DTC

With the scan tool, clear all ECM DTCs.

Turn the ignition on and off several times pausing 10 seconds between key cycles.

With the scan tool, select View DTCs in the ECM.

Is the status Active for this DTC?

Yes

- Go to 3

No

- Refer to *CHECKING FOR INTERMITTENT DTC in the symptom list. Checking for an Intermittent DTC

3. REPROGRAM IGNITION KEYS AND RETEST

With the scan tool, clear all ignition keys out of SKREEM memory.

With the scan tool, reprogram all ignition keys to the SKREEM.

Turn the ignition on and off several times pausing 10 seconds between key cycles.

With the scan tool, select View DTCs in the ECM.

Is the status Active for this DTC?

Yes

- 4

No

- Test complete.


4. REPLACE THE SKREEM AND RETEST

Replace and program the SKREEM.

Turn the ignition on.

With the scan tool, clear all ECM DTCs.

Turn the ignition on and off several times pausing 10 seconds between key cycles.

With the scan tool, select View DTCs in the ECM.

Is the status Active for this DTC?

Yes

- Replace and program the Engine Control Module.
- Perform the ECM Verification Test Ver. 1. ECM Verification Test

No

- Test complete.