B163C

B163C-FRONT LEFT TURN CONTROL CIRCUIT HIGH





For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
Continuously

- Set Condition:
When the Front Control Module detects a short to battery on the Control circuit.





Diagnostic Test

1. TEST FOR INTERMITTENT CONDITION
Turn the ignition on.
Clear all FCM DTC's.
Turn the Left Turn Signal on.
With the scan tool, read DTC's.
Does the scan tool read: B163C-FRONT LEFT TURN CONTROL CIRCUIT HIGH?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

2. FRONT LEFT TURN SIGNAL BULB
Turn the ignition off.
Inspect the Front Left Turn Signal Bulb Assembly.
Is the inoperative bulb OK?

Yes

- Go To 3

No

- Replace the Inoperative bulb.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

3. L61 LEFT TURN SIGNAL CONTROL CIRCUIT OPEN




Turn the ignition off.
Disconnect the FCM C2 connector.
Measure the resistance of the (L61) Front Left Turn Signal Control circuit.
Is the resistance above 5.0 ohms?

No

- Repair the (L61) Turn Signal Control circuit for an open.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

Yes

- Replace the Front Control Module.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test