Clearing Diagnosis Trouble Codes (U.S.A Only)

When a fault has been corrected, the fault code must be cleared. This is done by performing the following procedure:
1. Put the Ignition Switch (X134) in position II.
2. Disconnect the MFI Data Link Connectors (X127) and wait 5 seconds. Reconnect MFI Data Link Connectors.
3. Put the Ignition Switch (X134) in position 0 and wait till the load relay drops out.
4. Put the Ignition Switch (X134) in position II. The display will be blank if no other faults exist. If other codes exist, the next diagnostic trouble code will be displayed.
5. If multiple faults exist, repeat steps 1 through 4 until all faults are cleared.

Code 02 indicates that the ECM has just been reconnected. Switch the Ignition Switch (X134) to position II to clear code 02.