Intermediate Shaft Rear Bearing Replacement

REMOVAL
1. Remove intermediate shaft drive gear.





2. Remove 2 magnets from rear casing.
3. Release oil strainer clip from rear casing.
4. Expand snap ring retaining intermediate shaft rear bearing to rear casing.
5. Remove intermediate shaft, oil pump and strainer assembly from rear casing.
6. Remove circlip retaining intermediate shaft bearing to intermediate shaft.
7. Using a suitable puller, remove bearing from rear of intermediate shaft.

INSTALLATION
1. Ensure bearing and intermediate shaft mating surfaces are clean and free of burrs.
2. Press bearing onto intermediate shaft.
3. Install circlip retaining bearing to intermediate shaft.
4. Expand snap ring in rear housing and install intermediate shaft assembly to rear casing.
5. Ensure snap ring is correctly located to rear bearing.
6. Install filter hose clip to rear casing.
7. Install magnets to rear casing.
8. Install intermediate shaft drive gear.