Campaign - Transfer Case Label Replacement
No: H106Ref:
*Issue: 2
Date: 01/15/03*
SERVICE ACTION
Transmission Label Replacement
AFFECTED VEHICLE RANGE:
*Discovery Series II (LT) 3A767790 up to 3A795059*
Updated information is shown by asterisks.
SITUATION:
INCORRECT LABEL INSTALLED AT PRODUCTION
A "universal" label utilized in production from the start of the 2003 Model Year incorrectly indicates that North American-specification vehicles are equipped with the differential lock feature.
RESOLUTION:
REPLACE TRANSMISSION LABEL
*Prior to retail sale or at the next service opportunity, 2003 Discovery vehicles within the above VIN range should be inspected to ensure that the correct label is installed. The incorrect "universal" shift position label should be replaced with the correct specification label that makes no reference to differential lock.*
PARTS INFORMATION:
AWR6472 Transmission Label Qty 1
LRN0002LABEL Service Action Label Qty 1 (Sold in quantity pack of 100)
WARRANTY CLAIMS:
NOTE:
Service Campaign Option codes will be letters instead of numbers in the future as the result of program changes to Land Rover warranty processes.
H106 (Option C) Time 0.10 hrs.
Install replacement transmission label
Normal warranty policy and procedures apply.
Material allowance is included in labor operation.
REPAIR PROCEDURE
INSTALL NEW-SPECIFICATION LABEL
CAUTION:
Damage to the center console may result if care is not taken when removing the label. No metallic or sharp objects should be used.
1. If the incorrect "universal" label is installed on the vehicle, note the position of the label on the console and carefully remove. (Figure 1)
2. Ensure the surface of the console is clean and free from any residue of the old label.
3. Peel the backing off the new label (Figure 2).
4. Carefully align label to the flattened label location on the console.
5. Adhere the upper edge of the label at the upper edge of the label mounting area.
6. Apply even pressure over the full surface area of the label to ensure full adhesion
INSTALL CAMPAIGN LABEL
NOTE:
Campaign labels may have multiple Campaign numbers written on them if multiple campaigns are performed at the same time.
1. When all specified repairs have been accomplished, prepare the campaign label (LRN0002LABEL) as follows:
a) Place the label on a hard surface.
b) Use a ballpoint pen to neatly write/scribe in the bare aluminum areas of the label the following information:
^ Campaign code H106"
^ Your retailer code
^ The date of repair
2. Clean all grease and dirt from the radiator support member.
3. Peel the completed campaign label from the backing paper and position it on the cleaned area.
4. Roll the label with the special roller tool to ensure proper adhesion.