Joints and Joint Faces

Joints And Joint Faces

General
Fit joints dry unless specified otherwise.
- Always use the correct gaskets as specified.
- When jointing compound is used, apply in a thin uniform film to metal surfaces: take care to prevent jointing compound from entering always, pipes or blind tapped holes.
- If gaskets and/or jointing compound is recommended for use; remove all traces of old jointing material prior to reassembly. Do not use a tool which will damage the joint faces and smooth out any scratches or burrs using an oil stone. Do not allow dirt or jointing material to enter any tapped holes or enclosed parts.
- Prior to reassembly, blow through any pipes, channels or crevices with compressed air.