P1715

JATCO Fault P1715 - Intermediate Sensor

P1715 - Intermediate speed sensor no signal.

Possible causes:
1. Open Circuit C243/4(R) to C932/21(R).
2. Open Circuit C243/3(B) to C932/20(KB).
3. Short Circuit C243/4(R) to Ground or Battery.
4. Short Circuit C243/3(B) to Ground or Battery.
5. Connectors C243,C932.
6. Intermediate speed sensor.
7. JATCO ATCU ECU.

1. Open Circuit C243/4(R) to C932/21(R).
OPEN_CIRCUIT
Check resistance > 1M Ohms.

2. Open Circuit C243/3(B) to C932/20(KB).
OPEN_CIRCUIT
Check resistance > 1M Ohms.

3. Short Circuit C243/4(R) to Ground or Battery.
SHORT_CIRCUIT
Check resistance < 5.0 Ohms.

4. Short Circuit C243/3(B) to Ground or Battery.
SHORT_CIRCUIT
Check resistance < 5.0 Ohms.

5. Connectors C243,C932.
CONNECTOR
Check for connector not correctly latched, backed out pins, damaged pins, corroded pins

6. Intermediate speed sensor.
If the vehicle speed exceeds 25 mph (40 kph) while the Intermediate sensor reads less than 600 rpm then, after a period of two seconds, an 'Intermediate Sensor Failure' fault is reported.

7. JATCO ATCU ECU.
No detail available for this fault