Parking Brake System: Specifications

System Specifications





Service
The servicing requirements for the handbrake fever end cable system are minimal. However, the handbrake cables remain a serviceable item and will need to be periodically replaced. The cables will always be in tension due to the automatic adjuster end this tension must tee released in order to facilitate replacement. The process to achieve this is 85 follows:
1 Lower handbrake to rest position
2 Release gaiter from center console and roll back to expose lever assembly
3 Remove access panel from rear of center console
4 Pull back equalizer until adjuster spring is fully compressed
5 Replace pin. A suitably sized pin of adequate strength (preferably steel) may be used
6 Replace cables
7 Remove pin. The pin may be removed with the handbrake in any position
8 Replace gaiter and rear access panel.