Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor

Service Repair No - 18.30.12

Removal
1 Disconnect the battery ground cable.
2. Raise and support the vehicle.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

3. Remove the engine undershield.
4. Remove the CKP sensor.
^ Disconnect the electrical connector.
^ Remove the Torx screw.

CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.





Installation
1 Install the CKP sensor.
^ Tighten the Torx screw to 8 Nm (6 ft. lbs.).
^ Connect the CKP sensor electrical connector.

2 Install the engine undershield.
3 Connect the battery ground cable.