Gear Sensor/Switch: Service and Repair
High/Low Range SensorService Repair No - 41.30.07
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the crossmember.
3. CAUTION: To avoid damage to the joints or gaiters, do not allow the transmission to hang on the driveshafts.
Remove the mode sensor.
^ Lower the rear of the transmission for access.
^ Disconnect the electrical connector.
^ Remove the 2 Torx bolts.
Installation
1. To install, reverse the removal procedure.
^ Clean the components.
^ Tighten the Torx bolts to 10 Nm (7 lb.ft).
2. Install the crossmember.
3. Use T4 to re-calibrate a new mode sensor.