Maintenance Required Lamp/Indicator: Service and Repair

Reset Procedure

There are two ways of resetting the service interval indicator. T4 can be connected to the vehicle and diagnostic routine performed or a manual reset procedure using the trip reset button on the instrument cluster.


Manual Reset Procedure

1. Press and hold the trip reset button.

2. Turn the ignition switch on to the ignition position II.

3. If the SII function is set in the CCF the information display will show "SERVICE". If the SII function is not set in the CCF the information display will show the normal odometer and trip information.

4. The software will check if remaining distance service is enabled.

5.
^ If the trip reset button is not released after 10 seconds, the display will show the next service type and distance/days to next service and the instrument cluster will exit the manual reset procedure.

6. If the oil service value reset is not required, press the trip reset button within 10 seconds of releasing it in step 5 and hold for less than 5 seconds and proceed to step 8. This will by-pass the oil service reset procedure.

7. If the oil service value is to be reset, press the trip reset button within 10 seconds of releasing it and hold for more than 5 seconds. The information display will show "RESET" for 5 seconds and then reset the oil service value.

^ If reset is not possible, the information display will show "CANNOT RESET" for 5 seconds.

8. The information dispaly will show "INSPECT"

9. If the trip reset button is released within 10 seconds of entering the reset mode, the information display will show "OIL".

^ If the trip reset button is not released after 10 seconds, the display will show the next service type and distance/days to next service and the instrument cluster will exit the manual reset procedure.

10. If the periodic inspection value reset is not required, press the trip reset button withing 10 seconds of releasing it in step 5 and hold for less the 5 seconds and proceed to step 8. This will by-pass the periodic inspection reset procedure.

11. If the periodic inspection value is to be reset, press the trip reset button within 10 seconds of releasing it and hold for more than 5 seconds. The information display will show "RESET" for 5 seconds and then reset the periodic inspection value.

^ If the reset is not possible, the information display will show "CANNOT RESET" for 5 seconds.

12. The information display will show "DATE".

13. If the trip reset button is released within 10 seconds of entering the reset mode, the information display will show "END".

^ If the trip reset button is not released after 10 seconds, the display will show the next service type and distance/days to next service and the intstrument cluster will exit the manual reset procedure.