Brake Lamp: Service and Repair

Rear Lamp Assembly

Service Repair No - 86.40.70

Removal
1. Open the liftgate.
2. Release the rear lamp assembly.
^ Remove the 2 screws.
^ Release the 2 clips.
3. Remove the rear lamp assembly.
^ Disconnect the electrical connector.





NOTE:
^ Do not disassemble further if the component is removed for access only.
^ Note the fitted position.

4. Remove the wiring harness.
^ Release the 5 bulb holders.
^ Release the electrical connector.
5. Remove the 5 bulbs.





Installation
1. Install the bulbs.
2. Install the wiring harness.
^ Install the bulb holders.
^ Install the electrical connector.
3. Install the rear lamp assembly.
^ Connect and secure the electrical connector.
^ Secure the clips.
^ Tighten the screws.
4. Close the liftgate.