Ride Height Sensor: Service and Repair

Suspension Height Sensor

Service Repair No - 60.36.01


Removal

1. NOTE: The right hand sensor has a black colored lever and the left hand sensor has a white colored lever.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
2. Remove the wheel and tire.





3. CAUTION: Do not use excessive force to disconnect the height sensor link.

Remove the suspension height sensor.
^ Disconnect the height sensor link arm.
^ Disconnect the electrical connector.
^ Remove the 2 Torx screws.

Installation
1. To install, reverse the removal procedure.
^ Tighten the screws to 2.2 Nm (1.5 ft. lbs.).

2. CAUTION: Height suspension calibration, using T4, must always be carried out if the suspension height sensor fixings are removed.

Use T4 to re-calibrate the suspension system.