Front Fender: Service and Repair

Fender

Service Repair No - 76.10.24

Removal

1. Remove the plenum chamber panel.
2. Remove the front bumper cover.
3. Remove the fender splash shield.
4. Remove the fender moulding.
^ Release the 4 clips.





5. NOTE: Right-hand shown, left-hand similar.

Remove the fender air intake grille.
^ Release the 9 clips.
^ Remove the air ducting.





6. Remove the bumper cover clip.
^ Remove the 2 bolts.





7. Remove the front fender.
^ Remove the 5 Torx bolts.
^ Remove the nut.





8. NOTE: Do not disassemble further if the component is removed for access only.

Remove the fender rear trim.
^ Remove the 3 clips.





Installation

1. Install the fender rear trim.
^ Secure in the 3 clips.

2. Install the front fender.
^ Install the bolts and tighten to 10 Nm (7 ft. lbs.).
^ Install the nut and tighten to 10 Nm (7 ft. lbs.).

3. Install the front bumper clip.
^ Install the bolts and tighten to 6 Nm (4 ft. lbs.).

4. Install the fender air intake grille.
^ Install the air ducting.

5. Install the fender moulding.
^ Secure in the clips.

6. Install the fender splash shield.
7. Install the front bumper cover.
8. Install the plenum chamber panel.