Component Tests

Component Tests

Poor Retraction
If a safety belt does not retract correctly, check that the anchor covers and trim bezels are correctly installed and not rubbing against the safety belt webbing. Where necessary, check the safety belt webbing is not rubbing at one end of the retractor cover slot and if so, correct by loosening the retaining bolt, aligning the retractor to centralize the safety belt webbing and re-tighten the bolt.
The vehicle is equipped with two front and three rear inertia reel safety belts. These safety belts are "dual sensitive" which means that they have:
- a vehicle motion sensor, which locks the safety belt webbing under braking, cornering, on steep hills and in adverse camber conditions.
- a webbing motion sensor, which locks when the safety belt webbing is quickly extracted.
Both systems should be fully operational and can be checked by the tests below: