Maintenance Required Lamp/Indicator: Service and Repair

Service Interval Indicator Reset


When a service has been carried out, the SII will need to be re-set. This can be done using the Land Rover approved diagnostic system or following a manual re-set procedure. The manual re-set mode is entered by carrying out the following routine:

^ Press and hold the trip reset button with the vehicle stationary and in a power mode less than 6.
^ While holding the trip reset button, enter the vehicle into power mode 6.
^ Release the trip reset button within 10 seconds of entering power mode 6.

If the manual re-set mode has been successfully entered "dISt" or "DATE" will be displayed in the odometer, depending on which trigger has been activated.

To clear the "dISt" trigger press, and hold the trip reset button for more than 5 seconds within 10 seconds of entering the manual re-set mode. If successful, "RESET" will be displayed in the odometer for 5 seconds. If the date trigger has not been activated "END" will then be displayed in the odometer.

NOTE:
The distance trigger will not reset if the distance the vehicle has traveled is less than 20% of the next service interval value.

If the date trigger has been activated, "DATE" will be displayed in the odometer. To clear the trigger, press and hold the trip reset button for more than 5 seconds within 10 seconds of "DATE" being displayed. If successful, "RESET" will be displayed within the odometer for 5 seconds followed by "END". The odometer will now exit re-set mode.