Trunk / Liftgate: Adjustments

Liftgate Alignment

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.




1 With the liftgate closed, check the alignment of the liftgate to the roof panel and bodyside panel. The liftgate should be central in its aperture.
For additional information, refer to Rear Spoiler Service and Repair




2 Loosen, but do not remove the liftgate hinge bolts.





NOTE:
Make sure that the tailgate is flush with the fender at point 1.

NOTE:
Make sure that the tailgate is recessed by 1.5 mm in relation to the fender, at point 2.
3 Position the liftgate central to the aperture.
4 Tighten the liftgate hinge bolts.
Torque to: 24 Nm
5 Check for correct operation of the liftgate, and if necessary adjust the liftgate striker.
For additional information, refer to Liftgate Striker Adjustment Adjustments