Electronic Parking Brake (EPB) Service Mode Activation And Deactivation

Electronic Parking Brake (EPB) Service Mode Activation and Deactivation

CAUTION: This procedure requires the vehicle in the Park or Neutral position, with the ignition turned ON (the engine must be OFF) and the parking brake system released.

NOTE:
This procedure allows the parking brake to be released when removing and installing new rear brake pads or brake discs.
1 Press and hold the parking brake switch in the release position.
2 Wait 2 seconds.
3 Press and hold the accelerator pedal in the wide open throttle position.
4 Wait 2 seconds.
5 Turn the ignition Off and back On immediately.

NOTE:
An audible noise will be heard to confirm that the parking brake has been released in Service Mode.
6 Release the accelerator pedal and release the parking brake switch to the neutral position.

CAUTION: This procedure requires the vehicle in the Park or Neutral position, with the ignition turned ON (the engine must be OFF) and the parking brake system in Service Mode.

CAUTION: Once the rear brake pads or brake discs have been installed, the Service Mode must be cancelled.
1 Press and hold the parking brake switch in the apply position.
2 Wait 2 seconds.
3 Press and hold the accelerator pedal in the wide open throttle position.
4 Wait 2 seconds.
5 Turn the ignition Off and back On immediately.

NOTE:
An audible noise will be heard to confirm that the parking brake has been released from the Service Mode.
6 Release the accelerator pedal and release the parking brake switch to the neutral position.