Instrument Panel

Instrument Panel
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
Removal steps in this procedure may contain installation details.
1 Make the SRS system safe.
For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Disconnect the battery ground cable.
For additional information, refer to Specifications

NOTE:
The procedure must be carried out on both sides.
For additional information, refer to Cowl Side Trim Panel Cowl Side Trim Panel
For additional information, refer to Steering Column Service and Repair
For additional information, refer to Windshield Wiper Motor Service and Repair
For additional information, refer to Thermostatic Expansion Valve - 2.0L GTDI Service and Repair

NOTE:
The procedure must be carried out on both sides.
For additional information, refer to Front Door Service and Repair
For additional information, refer to Glove Compartment Service and Repair
For additional information, refer to Front Seat Removal and Replacement
For additional information, refer to Floor Console Floor Console





NOTE:
The step must be carried out on both sides.

Torque to: 6 Nm





NOTE:
The step must be carried out on both sides.

















































CAUTION: Make sure that all openings are sealed. Use new blanking caps.
3 Clamp the hoses to minimize coolant loss.





Torque to: 40 Nm





Torque to: 24 Nm





NOTE:
Right-hand shown, left-hand similar.

NOTE:
The step must be carried out on both sides.

Torque to: 24 Nm





NOTE:
Right-hand shown, left-hand similar.

NOTE:
The step must be carried out on both sides.

Torque to: 40 Nm





CAUTION: Protect the surrounding trim to avoid damage.

NOTE:
With assistance remove the component.

Torque to: 24 Nm

Installation
1 To install, reverse the removal procedure.
2 Check and top-up the coolant if required.