Canada - Doors - Initialization Of Power Back Door
BulletinTSB2047
Issue Date
January 07, 2004
Title
INITIALIZATION OF POWER BACK DOOR
Component
GENERAL INFORMATION
Models
'05 - '06 RX 330
TSB REVISION NOTICE:
- August 25, 2005: 2006 model year has been added to Applicable Vehicles.
The previous TSB should be discarded.
INTRODUCTION:
As a result of the removal of the Short Pin, the "automatic open and close" and "jam protection" functions of the Power Back Door will be inoperative due to loss of the Power Back Door position memory stored in the microcomputer.
Initialize the Power Back Door after installing the Short Pin in its original location during Pre-Delivery Service at the dealership.
NOTE:
Any time the battery terminal has been disconnected, initialize the Power Back Door after reconnecting the battery terminal.
APPLICABLE VEHICLES:
- 2005 - 2006 model year RX 330 vehicles.
WARRANTY INFORMATION:
INITIALIZATION PROCEDURE:
1. Fully Close The Power Back Door.
2. Cycle Power Back Door to Fully Open and Fully Closed Position.
A. Unlock the power back door using the unlock button on the transmitter switch or the door control switch.
B. Check that the ignition switch is in the "OFF" position, and make sure the power back door off switch is in the "ON" position.
C. Check that the back door fully opens and fully closes by pushing the power back door switch (open/close) or the "PWR DOOR" button briefly on the transmitter switch.
NOTE:
Jam protection function is enabled through the above initialization procedure.