Removal

3UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: REMOVAL

3UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: REMOVAL

1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH Removal

2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH Removal

3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Removal

4. REMOVE ENGINE ROOM SIDE COVER LH Removal

5. REMOVE ENGINE ROOM SIDE COVER RH Removal

6. REMOVE UPPER RADIATOR SUPPORT SEAL Removal

7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
- w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

9. REMOVE AIR CLEANER HOSE ASSEMBLY Removal

10. REMOVE AIR CLEANER ASSEMBLY Removal

11. REMOVE FAN AND GENERATOR V BELT Removal

12. DRAIN POWER STEERING FLUID
13. REMOVE FRONT WHEEL
14. REMOVE FRONT FENDER APRON SEAL FRONT RH Removal

15. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH






(a) Disconnect the connector.
(b) Remove the nut, bolt and sensor.
16. REMOVE POWER STEERING OIL PRESSURE SWITCH






(a) Disconnect the switch connector.
(b) Using a 24 mm deep socket wrench, remove the oil pressure switch.
(c) Remove the O-ring.