C2114

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: C2111/11: Transmitter ID1 Operation Stop

DTC C2111/11 - Transmitter ID1 Operation Stop

DTC C2112/12 - Transmitter ID2 Operation Stop

DTC C2113/13 - Transmitter ID3 Operation Stop

DTC C2114/14 - Transmitter ID4 Operation Stop

DTC C2115/15 - Transmitter ID5 Operation Stop

DESCRIPTION

The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the air pressures of the tires. The measured values are transmitted to the tire pressure warning receiver with antenna on the body as radio waves and then sent to the tire pressure warning ECU. The ECU compares the measured air pressure values with the air pressure threshold. When the measured air pressure value is less than this threshold, the warning light in the combination meter comes on. The tire pressure warning ECU stores a DTC when the tire pressure warning valve and transmitter stops transmitting signals. At this time, forcibly transmit the signals by releasing the tire pressure rapidly. The stored DTC is cleared when the signal transmission is resumed.





HINT: It is necessary to perform the procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because it cannot be identified by the output DTC.

WIRING DIAGRAM





INSPECTION PROCEDURE
NOTE: It is necessary to perform initialization after registration of the transmitter IDs into the tire pressure warning ECU after the ECU or valve and transmitter has been replaced.

PROCEDURE

1. PERFORM FORCED TRANSMISSION OF TRANSMITTER ID OF ALL WHEELS
(a) Set the tire pressure to the specified value.
Cold tire inflation pressure:






*1: For driving under 100 mph (160 km/h)
*2: For driving at 100 mph (160 km/h) or more
(b) Connect the intelligent tester to the DLC3.
(c) Turn the ignition switch to the ON position.
(d) Select "TIREPRESS" by following the prompts displayed on the intelligent tester.





(e) Rapidly release the pressures from each wheel by approximately 40 kPa (0.4 kgf/cm2, 5.8 psi) / 30 seconds or more.
(1) Check that each tire pressure data displayed on the intelligent tester screen has changed.
OK:
Each tire pressure data displayed on the intelligent tester screen will change to the value of the tire pressure.
NOTICE:
- It takes about 1 minute or more to display the updated tire pressure data.
- When the "TIREPRESS" data has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees (including the spare tire). Then rapidly release the tire pressure and recheck it.

(2) After confirming that all of the tire pressure data displayed on the intelligent tester screen have changed, set the tire pressures to the appropriate specified values.
HINT: If the tire pressure data displayed on the intelligent tester screen has not changed after rechecking, go to other problem procedure (For malfunction in transmission or reception function, Problem Symptoms Table.)

NG -- INSPECT OTHER PROBLEM
OK -- END