Chassis - General Maintenance

MAINTENANCE: CHASSIS: GENERAL MAINTENANCE

GENERAL MAINTENANCE

1. INSPECT STEERING LINKAGE
(a) Check the steering linkage for looseness or damage.
Check that:
- Tie rod ends do not have excessive play.
- Dust seals and boots are not damaged.
- Boot clamps are not loose.

2. INSPECT DRIVE SHAFT BOOTS
(a) Inspect the drive shaft boots for clamp looseness, grease leakage or damage.
3. INSPECT BALL JOINT AND DUST COVER






(a) Inspect the ball joints for excessive looseness.
(1) Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.
(2) Lower the jack until there becomes about half a load on the front coil spring. Place stands under the vehicle for safety.
(3) Check that the front wheels are pointing straight ahead, and block them with chocks.
(4) Using a lever, pry up the end of the lower arm, and check the amount of play.
Maximum ball joint vertical play:
0 mm (0 in.)
If there is any play, replace the ball joint.






(b) Check the dust cover for damage.
4. CHECK HYBRID TRANSAXLE
(a) Visually check the transaxle for oil fluid leakage.
Q211 Hybrid Transaxle for Q211 transaxle)
Transaxle Fluid for P310 transaxle)
5. ROTATE TIRES
Component Tests and General Diagnostics