Installation

3UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: INSTALLATION

1. INSTALL POWER STEERING OIL PRESSURE SWITCH

(a) Install a new O-ring to the oil pressure switch.

(b) Apply a light coat of engine oil to the O-ring of the oil pressure switch.

NOTICE:
* When reusing the oil pressure switch, inspect the O-ring.
* If the O-ring has scratches or cuts, replace the new O-ring.
(c) Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)





(d) Connect the oil pressure switch connector.

2. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

(a) Install the sensor with the bolt and nut.

for bolt - Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)

for nut - Torque : 5.6 Nm (57 kgf-cm, 50 in-lbf)





(b) Connect the connector.

3. INSTALL FAN & GENERATOR V BELT Installation

4. INSTALL AIR CLEANER ASSEMBLY Installation

5. INSTALL AIR CLEANER HOSE ASSEMBLY Installation

6. ADD POWER STEERING FLUID

7. BLEED POWER STEERING FLUID Power Steering System

8. INSPECT FOR POWER STEERING FLUID LEAK

9. INSTALL FRONT FENDER APRON SEAL FRONT RH Installation

10. INSTALL FRONT WHEEL Installation

11. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Installation

12. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH Installation

13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH Installation

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION Installation

16. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY Height Control Sensor (for Front Side)

17. PERFORM ZERO POINT CALIBRATION OF G SENSOR Installation

18. ADJUST HEADLIGHT ASSEMBLY Installation

19. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

20. INSTALL UPPER RADIATOR SUPPORT SEAL Installation

21. INSTALL ENGINE ROOM SIDE COVER RH Installation

22. INSTALL ENGINE ROOM SIDE COVER LH Installation