Ignition Coil: Service and Repair

PROCEDURE

Removal




1. Disconnect Negative (-) Terminal Cable From Battery.

CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the "LOCK" position and the negative (-) terminal cable is disconnected from the battery.





2. Remove V-bank Cover; Using a 5 mm hexagon wrench, remove the 2 cap nuts and V-bank cover.
3. Disconnect Ignition Coil Connectors.





4. Remove the six bolts and six Ignition Coils from the cylinder heads.





NOTE: Arrange the Ignition Coils in correct order.

Installation

1. Install the six Ignition Coils and secure with the six bolts.

Torque: 8 Nm (69 in lb)

2. Connect the six Ignition Coil connectors.
3. Reinstall V-bank Cover; Using a 5 mm hexagon wrench, install the V-bank cover with the 2 cap nuts.

NOTE: when repositioning the V-bank cover, push on the cover until a "click" is felt.

7. Reconnect Negative (-) Terminal Cable To Battery