Fuel Pressure Pulsation Damper: Service and Repair

REMOVAL




1. REMOVE STARTER.






2. REMOVE FUEL PRESSURE PULSATION DAMPER.
- Using SST, remove the pulsation damper and upper gasket.
SST 09612-24014 (09617-24011)
- Disconnect the fuel inlet pipe from the fuel pipe sup- port, and remove the lower gasket.



INSTALLATION
1. INSTALL FUEL PRESSURE PULSATION DAMPER.





- Install the fuel inlet pipe and pulsation damper with 2 new gaskets.

HINT: Different the gaskets are used for the upper (large size) and lower (small size).





- Using SST, tighten the pulsation damper.
SST 09612-24014 (09617-24011)

Torque:
41 N.m (420 kgf.cm1 30 ft.lb.)
35 N.m (350 kgf.cm, 25 ft.lb.) for SST

HINT: Use a torque wrench with a fulcrum
length of 30cm (11.81 in.).

2. INSTALL STARTER.

3. CHECK FOR FUEL LEAKS.