Parking Brake Pedal: Service and Repair

Parking Brake Pedal Components:

REMOVAL
1. Remove these parts:
(a) Scuff plate.
(b) No.1 under cover.
(c) Finish plate.
(d) End pad.
(e) Outside rear view mirror switch.
(f) Lower pad.
2. Remove Parking Brake Pedal assembly.
(a) Disconnect the Parking Brake Switch connector.
(b) Remove the 2 bolts and Parking Brake Release Lever.
Torque: 5.4 Nm (55 kg.cm, 48 inch lbs.)
(c) Remove the bolt, 3 nuts and Parking Brake Pedal assembly.
Torque: 13 Nm (130 kg.cm, 9 ft. lbs.)
(d) Remove the pin clip and pull out the pin.
(e) Remove the clip and disconnect the Parking Brake wire.
3. Remove Parking Brake Switch from Parking Brake Pedal bracket.
4. Remove Parking Brake Release Lever.
5. Remove Parking Brake Pedal.
Remove the bolt, nut, 2 bushings. collar and pedal.
Torque: 32 Nm (330 kg.cm. 24 ft. lbs.)
6. If necessary, replace Shock Absorber.
(a) Loosen the union lock nut.
(b) Install the Shock Absorber to the pin on the pedal bracket side, then extend the piston rod fully.
(c) Return the pedal until it hits the cushion.
(d) Make adjustments so that the shock absorber's union and the pin on the pedal side are aligned, then turn the union 1 turn counterclockwise.

Installing The Shock Absorber To The Pin On The Pedal:

(e) Install the Shock Absorber to the pedal and tighten the lock nut.
Torque: 13 Nm (130 kg.cm, 9 ft. lbs.)

INSTALLATION
Installation is in the reverse order of disassembly.