Troubleshooting
TROUBLESHOOTINGPrecautions
1. When checking voltage. resistance. etc., use a high impedance type tester (It is impossible with a simple tester).
2. When the ignition switch is turned to START, all meters will go out but this is normal.
3. When replacing the internal mechanism (computer parts) of the meter, be careful that no part of your body or clothing comes in contact with the terminals of the leads from the IC, etc.of the replacement parts (spare parts).
4. Do not disconnect the battery while the engine is running as this would cause an instant reverse charge. resulting in damage to the components.
5. Always disconnect the battery terminals before pulling apart connectors or terminals.
6. To prevent damage. handle meters with care.
Troubleshooting / Combination Meter
ALL METERS, GAUGES, AND ILLUMINATIONS
1. No display at all
2. One indicator needle does not light up
3. The character plate is illuminated on one side
4. Brightness does not change even when light control switch is operated (OFF<->TAIL)
5. Brightness does not change even when rheostat volume is turned
6. Does not go out while starter running.
SPEEDOMETER
7. Speedometer does not operate while driving.
8. Vehicle speed signal (4P) faulty.
TACHOMETER
9. Tachometer does not operate while engine running.
FUEL GAUGE
10. Does not operate or operation is abnormal.
FUEL LEVEL WARNING
11. Warning light does not light up or always lights up.
ENGINE COOLANT TEMPERATURE RECEIVER GAUGE
12. Does not operate or operation is abnormal.
ODOMETER AND TWIN TRIP METER
13. Display does not alter during driving
14. Display is reset whenever ignition switch is turned off
ENGINE OIL LEVEL WARNING
15. Warning light does not light up
16. Warning light always lit up
ECT PWR INDICATOR
17. Abnormal operation or indicator does not light up.
CRUISE MAIN INDICATOR
18. Abnormal operation or indicator does not light up.
O/D OFF INDICATOR
19. Abnormal operation or indicator does not light up.
SHIFT POSITION INDICATOR
20. Abnormal operation or indicator does not light up.
TRAC OFF INDICATOR
21. Abnormal operation or indicator does not light up.
ABS WARNING
22. Abnormal operation or warning light does not light up.
HIGH BEAM INDICATOR
23. Abnormal operation or indicator does not light up.
TURN SIGNAL INDICATOR
24. Abnormal operation or indicator does not light up.
WINDOW WASHER LEVEL WARNING SWITCH
25. Abnormal operation or indicator does not light up.
Troubleshooting/Warning Lights and Indicator Light in Meter Cluster
You will find the cause of trouble more easily using the table shown below. In this table. the numbers indicate the order priority of the causes in trouble. Check each part in the order shown. If necessary, replace the parts.