Rear

HUB BOLT REPLACEMENT
1. Remove the rear wheel.
2. Remove the brake caliper and the disc.





3. Using the 09628 - 10011 SST, remove the hub bolt.
4. Install the hub bolt by doing the following.





a. Install a washer and nut to the hub bolt, as shown in the illustration.
b. Turn the wheel nut to pull the hub bolt through until the underside of the hub bolt head touches the axle hub.
5. Install the disc and the brake caliper.
6. Install the rear wheel.

NOTE: When installing the rear wheel, tighten it to 103 Nm (76 ft. lbs.).