Differential Mount: Service and Repair

1. Remove the differential.





2. Using the 09316 - 12010, 09570 - 24010 SST, remove the differential mounting cushion.

NOTE:
- When driving out the mounting cushion, be careful not to touch the suspension member with the SST.

- Align the SST straight so that the bolt of the SST is parallel with the center line of the mounting cushion.





- When installing the bolts to the left and right hand differential mounting cushions. make sure that the bolts are passed through the correct holes in the SST. as shown in the illustration.





3. Using the 09570 - 24010 SST, install the differential mounting cushion so that the marks are positioned, as shown in the illustration.

NOTE:
- Do not make a mistake with LH and RH aides or top and bottom.

- Set the SST after temporarily Installing the differential mounting cushion into the member so as not to be installed at an angle.

- To confirm that the differential mounting cushion is aligned straight in relation to the member, check that the SST is fully in contact with all of the cushion.

4. Install the differential.