Headliner: Service and Repair
REMOVAL1. REMOVE FRONT SEAT
Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)
2. REMOVE REAR SEAT CUSHION
3. REMOVE REAR SEAT BELT FLOOR ANCHORS
Torque: 43 N.m (440 kgf.cm, 32 ft.lbf)
4. REMOVE REAR SEATBACK
Torque: 18 N.m (185 kgf.cm, 13 ft.lbf)
5. REMOVE FRONT DOOR SCUFF PLATES
6. REMOVE REAR DOOR SCUFF PLATES
7. REMOVE REAR SEAT SIDE GARNISHES
8. REMOVE HIGH-MOUNTED STOP LIGHT
9. REMOVE SPEAKER GRILLE
10. CANADA:
REMOVE CRS TETHER ANCHOR COVERS AND TETHER ANCHOR BRACKETS
Torque: 21 N.m (210 kgf.cm, 15 ft.lbf)
11. REMOVE CRS TETHER ANCHOR COVERS AND PACKAGE TRAY TRIM
12. REMOVE ASSIST GRIPS
13. REMOVE CENTER PILLAR GARNISHES
14. REMOVE REAR PERSONAL LIGHT
a. Remove the screw.
b. Using a screwdriver, remove the light as shown in the illustration.
HINT: Tape the screwdriver tip before use.
c. Disconnect the connector.
d. Employ the same manner described above to the other side.
15. REMOVE SPOT LIGHT
a. Using a screwdriver, remove the light as shown in the illustration.
HINT: Tape the screwdriver tip before use.
b. Disconnect the connector.
c. Employ the same manner described above to the other side.
16. REMOVE ROOF SIDE INNER GARNISH
a. Remove the roof side inner garnish.
NOTE: Paying enough attention remove the clip on the roof side inner garnish shown in the illustration. Otherwise, the roof side inner garnish or the front pillar garnish might be broken.
b. Employ the same manner described above to the other side.
17. REMOVE FRONT PILLAR GARNISH
a. Remove the front seat outer belt shoulder anchor.
b. Remove the front pillar garnish.
c. Employ the same manner described above to the other side.
18. REMOVE SUN VISORS AND HOLDERS
19. REMOVE PERSONAL LIGHT
20. REMOVE CENTER VISOR
21. REMOVE INNER REAR VIEW MIRROR
22. REMOVE FRONT ROOF HEADLINING AND ROOF HEADLINING
a. Pull the headlining backward and remove the front roof headlining.
b. Pull out the portion fitting around the sliding roof.
c. Using a clip remover,remove the 10 clips and release the fastener tapes, then remove the headlining.
NOTE: Do not fold down the headlining.
INSTALLATION
Installation Is in the reverse order of removal.