Road Test

ROAD TEST

PROBLEM SYMPTOM CONFIRMATION

HINT: The dynamic laser cruise control system has two cruise control modes: the constant speed control mode and vehicle-to-vehicle distance control mode.

- The vehicle-to-vehicle distance control mode is always selected when starting up the dynamic laser cruise control system.
- Operation of the constant speed control mode is the same as that for the conventional type cruise control system.




a. Inspect the SET function.
1. Push the ON-OFF button on.
2. Drive at the required speed (45 km/h (28 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. After releasing the switch, check that the vehicle cruises at the set speed.




b. Inspect the ACCEL function.
1. Push the ON-OFF button on.
2. Drive at the required speed (45 km/h (28 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. Check that vehicle speed increases while the cruise control main switch is pushed to RES/ACC, and that the vehicle cruises at the newly set speed when the switch is released.
5. Momentarily push the cruise control main switch to RES/ACC and then immediately release it. Check that vehicle speed increases (*1) (Tap-up function).

*1: Constant speed control mode: increases by 1.6km/h (1.0 mph), Vehicle-to-vehicle distance control mode: increases by 5km/h (5mph)




c. Inspect the COAST function.
1. Push the ON-OFF button on.
2. Drive at the required speed (45 km/h (28 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. Check that vehicle speed decreases while the cruise control main switch is pushed to SET/COAST, and the vehicle cruises at the newly set speed when the switch is released.
5. Momentarily push the cruise control main switch to SET/COAST, and then immediately release it. Check that vehicle speed decreases (*1) (Tap-down function).

*1: Constant speed control mode: decreases by 1.6km/h (1.0 mph), Vehicle-to-vehicle distance control mode: decreases by 5km/h (5mph)




d. Inspect the CANCEL function.
1. Push the ON-OFF button on.
2. Drive at the required speed (45 km/h (28 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. When doing one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.
- Depressing the brake pedal
- Moving the shift lever to any position except D (6th, 5th, and 4th gears)
- Pushing the ON-OFF button off
- Pulling the cruise control main switch to CANCEL




e. Inspect the RES (RESUME) function.
1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. When doing one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.
- Depressing the brake pedal
- Moving the shift lever to any position except D (6th, 5th, and 4th gears)
- Pulling the cruise control main switch to CANCEL

5. After pushing the cruise control main switch to RES/ACC at a driving speed of more than 40 km/h (25 mph), check that the vehicle restores the speed prior to the cancellation.

HINT: RESUME function (in the Vehicle-to-vehicle Distance Control Mode only)

The stored vehicle speed is retained even if vehicle speed goes below 40 km/h (25 mph) once. The previously stored vehicle speed can be resumed by pushing the cruise control main switch to RES/ACC when vehicle speed returned to approximately 40 km/h (25 mph) or more.