Replacement
REPLACEMENTHINT: Installation is in the reverse order of removal.
1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER LOWER
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL END
5. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1
6. REMOVE COIN BOX ASSEMBLY
7. REMOVE OUTER MIRROR SWITCH ASSEMBLY
8. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY NO.1
9. REMOVE INSTRUMENT PANEL AIR BAG ASSEMBLY LOWER NO.1
a. Disconnect the connector from the instrument panel air-bag assembly lower No.1.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
b. Remove the 4 bolts and the instrument panel airbag assembly lower No.1.
10. INSPECT INSTRUMENT PANEL AIR BAG ASSEMBLY LOWER NO.1
11. INSTALL INSTRUMENT PANEL AIR BAG ASSEMBLY LOWER NO.1
a. Install the instrument panel airbag assembly lower No.1 with the 4 bolts.
Torque: 10 Nm (102 kgf.cm, 7 ft.lbf)
b. Connect the connector to the instrument panel airbag assembly lower No.1.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
12. CONNECT BATTERY NEGATIVE TERMINAL
NOTE: When disconnecting the negative (-) battery terminal, initialize the system shown in the table after the terminal is reconnected.
13. INSPECT SRS WARNING LIGHT