Front Stereo Component Speaker

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE SPEAKER HOLE COVER




a. Using a screwdriver, detach the 4 clips and remove the hole cover.

HINT: Tape the screwdriver tip before use.

3. REMOVE FRONT STEREO COMPONENT SPEAKER ASSEMBLY




a. Remove the 2 bolts.
b. Disconnect the connector and remove the speaker.

HINT: Do not touch the cone part of the speaker.

INSTALLATION

HINT: A bolt without a torque specification is shown in the standard bolt chart.

1. INSTALL FRONT STEREO COMPONENT SPEAKER ASSEMBLY
a. Connect the connector.




b. Temporarily install the speaker by aligning the positioning pins of the speaker to the instrument panel.
c. Install the speaker with the 2 bolts.

HINT: Do not touch the cone part of the speaker.

2. INSTALL SPEAKER HOLE COVER




a. Attach the 4 clips to install the hole cover.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.