Center Mounted Brake Lamp: Service and Repair
HIGH MOUNTED STOP LIGHT ASSEMBLYREMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE HIGH MOUNTED STOP LIGHT ASSEMBLY
a. Detach the 2 claws and remove the stop light from the package tray trim center bracket.
b. Disconnect the connector.
3. REMOVE AUTOMATIC LIGHT CONTROL SENSOR
a. Disconnect the connector.
b. Detach the 2 claws and remove the sensor from the high mounted stop lamp base.
INSTALLATION
1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR
a. Connect the connector.
b. Attach the 2 claws and install the sensor to the package tray trim center bracket.
2. INSTALL HIGH MOUNTED STOP LIGHT ASSEMBLY
a. Connect the connector.
b. Attach the 2 claws and install the stop light to the package tray trim center bracket.
3. CONNECT CONNECT BATTERY NEGATIVE TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal