Rear

REAR BRAKE

COMPONENTS (Part 1):

COMPONENTS (Part 2):

REMOVAL
1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID

NOTICE: If brake fluid leaks onto any painted surface, wash off and remove it completely.





3. DISCONNECT REAR BRAKE FLEXIBLE HOSE
(a) Remove the union bolt and the gasket from the rear disc brake cylinder assembly, then disconnect the flexible hose.





4. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY
(a) Hold the 2 rear disc brake cylinder slide pins and remove the 2 bolts and rear disc brake cylinder assembly.

INSTALLATION





1. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY
(a) Install the disc brake cylinder assembly with the 2 bolts.
Torque: 27 N*m (273 kgf*cm, 20 ft.*lbf)

NOTICE: Install the rear disc brake bushing dust boot onto the groove of the rear disc brake cylinder.





2. CONNECT REAR BRAKE FLEXIBLE HOSE
(a) Connect the flexible hose with the union bolt and a new gasket.
Torque: 33 N*m (337 kgf*cm, 24 ft.*lbf)

3. FILL RESERVOIR WITH BRAKE FLUID
4. BLEED BRAKE LINE
5. BLEED BRAKE ACTUATOR ASSEMBLY
6. INSPECT FLUID LEVEL IN RESERVOIR
7. CHECK FOR BRAKE FLUID LEAKS
8. INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)