Removal and Replacement

Combination Meter:

COMBINATION METER

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

2. REMOVE FRONT DOOR SCUFF PLATE LH
3. REMOVE FRONT DOOR OPENING TRIM COVER LH
4. REMOVE SIDE INSTRUMENT PANEL LH
5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
6. REMOVE LOWER INSTRUMENT PANEL SUBASSEMBLY
7. REMOVE STEERING COLUMN COVER

a. Turn the steering wheel assembly to the right and remove the screw as shown in the illustration.

b. Turn the steering wheel assembly to the left and remove the screw as shown in the illustration.

c. Disengage the 2 claws and remove the steering column cover lower.

d. Disengage the claw and remove the steering column cover upper.

8. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a. Remove the screw.
b. Disengage the 2 clips.
c. Disengage the 4 claws and guide, and remove the instrument cluster finish panel sub-assembly.

9. REMOVE COMBINATION METER ASSEMBLY

a. Remove the 4 screws.

b. Disconnect the 2 connectors as shown in the illustration.

c. Remove the combination meter assembly as shown in the illustration.

INSTALLATION

1. INSTALL COMBINATION METER ASSEMBLY

a. Connect the 2 connectors as shown in the illustration.

b. Install the combination meter assembly as shown in the illustration.

c. Install the 4 screws.

2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a. Engage the guide and 4 claws.
b. Engage the 2 clips
c. Install the instrument cluster finish panel subassembly with the screw.

3. INSTALL STEERING COLUMN COVER

a. Engage the claw and install the upper steering column cover.

b. Engage the 2 claws.
c. Install the lower steering column cover with the 2 screws.

Torque: 2.0 N.m (20 kgf.cm, 18 in.lbf)

4. INSTALL LOWER INSTRUMENT PANEL SUBASSEMBLY
5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
6. INSTALL SIDE INSTRUMENT PANEL LH
7. INSTALL FRONT DOOR OPENING TRIM COVER LH
8. INSTALL FRONT DOOR SCUFF PLATE LH
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. PERFORM INITIALIZATION

NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal.