Dimmer Signal Circuit

AUDIO AND VISUAL SYSTEM: Dimmer Signal Circuit

Dimmer Signal Circuit

DESCRIPTION

The main body ECU sends a panel illumination signal to the radio receiver through this circuit.
The main body ECU determines the ambient brightness based on the light level detected by the automatic light control sensor and performs dim control.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BODY ECU)





(a) Disconnect the radio receiver connector E70 and main body ECU connector E60.
(b) Measure the resistance according to the values in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. INSPECT RADIO RECEIVER





(a) Connect the main body ECU connector.
(b) Turn the engine switch on (IG).
(c) Turn the light control switch to the TAIL or HEAD position.
(d) Measure the voltage according to the value(s) in the table below.
Standard voltage:






NG -- GO TO LIGHTING SYSTEM
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE