Power Source Circuit

MIRROR (EXT): POWER MIRROR CONTROL SYSTEM: Power Source Circuit

Power Source Circuit

DESCRIPTION

This is the power source circuit for the outer mirror control ECU.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK OUTER MIRROR CONTROL ECU (OUTER MIRROR CONTROL ECU POWER SOURCE)





(a) Disconnect the M10 connector*1.
(b) Disconnect the L10 connector*2.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:





HINT:
- *1: for LH side
- *2: for RH side

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR





(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE