Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL

1. PRECAUTION
CAUTION: Be sure to read Precaution thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

4. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal

5. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal

6. REMOVE CONSOLE PANEL SUB-ASSEMBLY Removal

7. REMOVE FRONT ASH RECEPTACLE ASSEMBLY Removal

8. REMOVE REAR ASH RECEPTACLE ASSEMBLY Removal

9. REMOVE CONSOLE BOX REGISTER ASSEMBLY Removal

10. REMOVE CONSOLE BOX Removal

11. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.





(c) Disconnect the holder (with connectors).
NOTICE: When disconnecting the airbag connector, take care not to damage the airbag wire harness.

(d) Remove the 2 bolts, nut and center airbag sensor assembly.