Kick Down Switch Circuit

AA80E AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSMISSION SYSTEM: Kick Down Switch Circuit

Kick Down Switch Circuit

DESCRIPTION

The kick-down switch turns ON when the accelerator pedal is fully depressed to send a signal to the ECM.
When the kick-down switch is ON, the ECM controls gear shifting according to the programmed shift diagrams.
If a short circuit develops in the kick-down switch, the ECM disregards the kick-down signals and controls shifting at the normal shift points.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (KICK DOWN SWITCH - BODY GROUND)
(a) Disconnect the kick-down switch connector.





(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. INSPECT KICK DOWN SWITCH ASSEMBLY





(a) Measure resistance according to the value(s) in the table below when kick-down switch is ON and OFF.
Standard Resistance:






NG -- REPLACE KICK DOWN SWITCH ASSEMBLY
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (KICK DOWN SWITCH - ECM)





(a) Connect the kick-down switch connector.
(b) Disconnect the ECM connector.
(c) Measure resistance according to the value(s) in the table below when accelerator pedal is fully depressed or not.
Standard Resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE