Installation
SUSPENSION: FRONT LOWER BALL JOINT: INSTALLATION
HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
* A bolt without a torque specification is shown in the standard bolt chart Specified Torque For Standard Bolts.
1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH
(a) Install the lower ball joint to the lower suspension arm.
(b) Install the nut and a new cotter pin.
Torque : 162 Nm (1,650 kgf-cm, 119 ft-lbf)
(c) Install the lower ball joint with the 2 bolts.
Torque : 113 Nm (1,150 kgf-cm, 83 ft-lbf)
2. INSTALL TIE ROD ASSEMBLY LH
(a) Install the tie rod to the lower ball joint.
(b) Install the nut and clip.
Torque : 87 Nm (890 kgf-cm, 64 ft-lbf)
3. INSTALL FRONT WHEEL
(a) Install the wheel with the 5 nuts.
Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)
4. STABILIZE SUSPENSION Installation
5. INSTALL WHEEL HUB ORNAMENT SUB-ASSEMBLY
(a) Install the ornament with the 10 bolts.
Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)